Conception d'un Compteur Mod-N en Verilog : Module Paramétré et Testbench

Conception

module modN_ctr # (
  parameter N = 10,
  parameter WIDTH = 4
) (
  input clk,
  input rstn,
  output reg[WIDTH-1:0] out
);
  always @ (posedge clk) begin
    if (!rstn) begin
      out <= 0;
    end else begin
      if (out == N-1) out <= 0;
      else out <= out + 1;
    end
  end
endmodule

Testbench

module tb;
  parameter N = 10;
  parameter WIDTH = 4;
  reg clk;
  reg rstn;
  wire [WIDTH-1:0] out;
  modN_ctr u0 ( .clk(clk), .rstn(rstn), .out(out) );
  always #10 clk = ~clk;
  initial begin
    {clk, rstn} <= 0;
    $monitor ("T=%0t rstn=%0b out=0x%0h", $time, rstn, out);
    repeat(2) @ (posedge clk);
    rstn <= 1;
    repeat(20) @ (posedge clk);
    $finish;
  end
endmodule

Journal de simulation

ncsim> run
T=0 rstn=0 out=0xx
T=10 rstn=0 out=0x0
T=30 rstn=1 out=0x0
T=50 rstn=1 out=0x1
T=70 rstn=1 out=0x2
T=90 rstn=1 out=0x3
T=110 rstn=1 out=0x4
T=130 rstn=1 out=0x5
T=150 rstn=1 out=0x6
T=170 rstn=1 out=0x7
T=190 rstn=1 out=0x8
T=210 rstn=1 out=0x9
T=230 rstn=1 out=0xa
T=250 rstn=1 out=0x0
T=270 rstn=1 out=0x1
T=290 rstn=1 out=0x2
T=310 rstn=1 out=0x3
T=330 rstn=1 out=0x4
T=350 rstn=1 out=0x5
T=370 rstn=1 out=0x6
T=390 rstn=1 out=0x7
T=410 rstn=1 out=0x8
Simulation complete via $finish(1) at time 430 NS + 0

Compteur Johnson 4 bits en Verilog – Conception, Testbench et Simulation Module Compteur Gray en Verilog – Générateur de Code Gray 4 bits

Verilog