Module Compteur Anneau en Verilog : Conception et Exemple de Testbench

Conception

module ring_ctr #(parameter WIDTH=4) (
  input clk,
  input rstn,
  output reg [WIDTH-1:0] out
);
  always @ (posedge clk) begin
    if (!rstn) out <= 1;
    else begin
      out[WIDTH-1] <= out[0];
      for (int i = 0; i < WIDTH-1; i=i+1) begin
        out[i] <= out[i+1];
      end
    end
  end
endmodule

Testbench

module tb;
  parameter WIDTH = 4;
  reg clk;
  reg rstn;
  wire [WIDTH-1:0] out;
  ring_ctr u0 (.clk (clk), .rstn (rstn), .out (out));
  always #10 clk = ~clk;
  initial begin
    {clk, rstn} <= 0;
    $monitor ("T=%0t out=%b", $time, out);
    repeat (2) @(posedge clk);
    rstn <= 1;
    repeat (15) @(posedge clk);
    $finish;
  end
endmodule

Journal de simulation

ncsim> run
T=0 out=xxxx
T=10 out=0001
T=50 out=1000
T=70 out=0100
T=90 out=0010
T=110 out=0001
T=130 out=1000
T=150 out=0100
T=170 out=0010
T=190 out=0001
T=210 out=1000
T=230 out=0100
T=250 out=0010
T=270 out=0001
T=290 out=1000
T=310 out=0100
Simulation complete via $finish(1) at time 330 NS + 0

Conception et Implémentation d'un Compteur Ripple Asynchrone en Verilog Compteur Johnson 4 bits en Verilog – Conception, Testbench et Simulation

Verilog